Impact and Collision Test Bench

Technical Specifications

1Temperature Usage:10—35℃

2No significant vibration sources or strong electromagnetic fields in the vicinity.

3The environment should be free of corrosive media, and attention should be paid to ensure good ventilation for the electrical control box.

4Power: AC220V±10% 2A

5Hammer Quality:0.5—6.3kg

6Workstation Schedule:10—400mm

7Sample Diameter:10—400mm

8Head Radius:D25 D90

9No Chinese content provided.2000mm

10High positioning accuracy: ±2mm

11Dimensions: Host Unit (Length x Width x Height)700mm×700mm×4000mm

12Unit Weight: Approximately450kg

Instructions

First, ground the control lines of the test bench, and then connect the communication lines together, ensuring each one corresponds to its numbered counterpart.

  Opening the box door to place the test item inside.VOn the form table, the length of the sample is (200±10）mmPlease refer to the specific details.GB/T 14152-2001Upon reaching the zero-position indicator light, stop the ascent and close the testing machine door.

After installing the required hammer according to national standards, power the control box, flip the power switch, and the indicator lights and gauge illuminate.

Instrument Settings: For example, set up1.5Mi Alarm, i.e., the elevator lift to1.5Press the rightward "△" key while the app is in working state to proceed.No Chinese content provided..A segment alarm value setting; here, skip directly to...No Chinese content provided..Two alarm thresholds set, press“SETDirect button jump toNo content provided for translation..No Chinese content provided.“AL2By pressing the "▲" key upwards to change the number, and by moving the cursor to the right with the "▲" key, set the value to001.500Proceed, then pressEXTPress key to exit menu settings.

Install the electromagnet-equipped elevator to the drop hammer assembly."Lower" button, the elevator descends until it contacts the hammer assembly, ensuring that the steel wire does not bend significantly. "This height measurement is more accurate," at which point, press the electromagnetic "clamp" button. The electromagnet is energized, clamping the hammer assembly, and simultaneously resetting the instrument's current display. PressRESTAfter the gauge reads zero, press the "Up" button, and the crane lifts the hammer lifting device until it reaches the set value.1.5After reaching the predetermined value, the elevator stops ascending. At this point, press the "Release" button, and the drop hammer device...1.5The Mian Yan guide rail vertically descends, and the hammer strikes the test sample, completing the test.

Open the test machine door to inspect the degree of sample destruction. If there is no damage, the tested sample is deemed qualified; otherwise, it is considered不合格.