Field Ventilated Plastic Track Construction Technology

Substrate Laying:

Before laying the sub-base material, clean the foundation base thoroughly, prepare the construction tools, and adjust the machine and its thickness according to the requirements of the construction drawings. The court features a breathable plastic track.

b. Properly divide the construction sections according to the engineering status, measure the position of the construction lines, and lay them down. Maintain consistent thickness of rubber particles during the laying process, ensuring seamless and traceless joints and connections.

Prior to laying the base material, the severely sunken areas of the foundation are leveled with underlayment and black granules, and the elevated spots are hammered down to achieve a smooth surface.

Before laying the base underlayment, thoroughly clean the sub-base and apply a layer of primer on the base surface. As you brush, lay down the black granular layer. It is not advisable to lay the black granular layer after the adhesive has cured, as it may affect adhesion. After applying a certain area of adhesive layer, immediately lay down the corresponding area of the black granular layer. Breathable plastic track for sports fields.

During the laying process, the laying personnel must ensure a uniform walking speed of the machine, while the trimming personnel should be skilled and timely apply adhesive to exposed areas and dents, smoothing out bumps and keeping the edges neat and even. There should be at least two trimming personnel.

f. After the black oak granules are laid and cured, inspect the entire area. Any uneven edges or irregularities should be trimmed, sanded, sealed, and adjusted to ensure the consistent thickness of the top layer.

③ Runway surface coating application:

After the black rubber granule layer has cured and shaped, the adhesive slurry layer (usually red) can be applied to its surface. The ratio is: EPDM granules to PU slurry = 1:1.2. First, mix the PU slurry with the appropriate amount of accelerator according to the ratio, ensuring thorough mixing. Add the EPDM granules during the mixing process, with particle size typically between 0.5 to 1mm. Then, pour the mixture into a professional spray gun and apply it to the surface of the black rubber granule layer. Adjust the consistency of the slurry by adding the appropriate amount of thinner during spraying. Apply the slurry evenly in two coats.

b. Prior to application, the adhesive sprayer must calculate the adhesive fluid usage, the length of adhesive applied per drum, make appropriate markings, and maintain a clear understanding to make the best use of materials. Athletic Track with Permeable Plastic Surface

c. Material handling should be clean and quick, pouring in stages to minimize spillage. Clean up any excess material at the bucket's edge promptly to maintain cleanliness outside the bucket, creating a favorable environment for the adhesive applicator.

④ Measurement and marking of the production line.

Xiamen Hongtong Flooring Co., Ltd. specializes in a variety of flooring projects, including industrial floors, epoxy floors, garage epoxy floors, non-slip epoxy chevron floors, sealant cured floors, retro floors, waterborne epoxy floors, acrylic court floors, and silicone PU floors.