Mitutoyo High-Precision Digital Micrometer 293-143-30

Mitutoyo Sinebar High Precision Digital Micrometer 293-143-30

Achieved rapid measurement of 2.0mm micro-screw feed per revolution of the differential sleeve. Increased thread pitch through high-precision thread processing and evaluation techniques with a spacing of 2.0mm.

● Hold with one hand to calculate the measurement time for continuous measurement of 6 segments of workpieces starting from a small diameter. Compared to traditional micrometers, the positioning and measurement times can be reduced by approximately 76%* and 58%*, respectively. *Survey of sampling operations.

● Equipped with a ratchet sleeve mechanism, reliable measurements without fluctuations can be achieved even by those not accustomed to single-handed measurements. Both the differential sleeve and the speed control device can be operated with a ratchet, ensuring stable measurements through the axial micro-vibration of the micrometer screw. The pressure state can also be confirmed audibly, and the ratchet on the speed control device facilitates rapid feeding of the micrometer screw.

■Features

Origin Setting:

(ABS Measurement System)

Press the ORIGIN button, at the current micrometer screw position

Reset ABS origin. Settable according to size variations.

Origin Value.

Set to Zero

(INC Incremental Measurement System)

Briefly press the ZERO/ABS button, on the current micrometer screw

Location setting displays as zero point, switch to incremental measurement

Quantity mode (INC), hold the button to reset to ABS measurement

Pattern

Data Hold: Press the Hold button to freeze the current value on the display.

A feature for operation under poor visibility conditions.

Before recording the reading, the instrument must be removed from the workpiece.

The measurement at the time of descaling is very useful.

Function Lock: This feature allows for locking the origin (origin setup) function

With zeroing (set to zero) function, to prevent these points from being accidentally

Reset.

Automatic Power Supply

Open/Close

If not in use for about 20 minutes, the LCD display

The reading on the display will disappear, but the origin is saved.

Adjust the micrometer screw to read on the LCD display.

Reemerging.

Data Output*: Micrometers with this feature have an output port.

Used for transferring measurement data to statistical process control

(SPC) System.

* Applies only to MDE-MX models.

Error Alert: If overflow appears on the LCD display or calculation

Error, error message appears on the LCD display.

Measurement function stopped. This will prevent the instrument from providing incorrect readings.

Misread values. When the battery voltage falls below a certain threshold, the measurement

Battery voltage low alert prior to normal operation.

The indicator will appear to remind users to change the battery.