Imported Olympus Multi-functional Conductivity Tester NORTEC 600 and probe, as well as test block

Conductivity probes are used for sorting non-ferrous metals and to determine heat treatment conditions or damage.

Conductivity probe for NORTEC 600

Adopting PowerlOlympus conductivity probes with ink technology are compatible with NORTEC 600 series instruments*. They are used for sorting metals and alloys, determining heat treatment conditions, and identifying damaged areas. The NORTEC 600 series instruments measure conductivity and display it as a digital reading in units of %IACS or MS/m, and also measure coating thickness or lift-off coefficient in units of inches or millimeters.

The conductivity probe operates at a frequency of 60 kHz or 480 kHz, equipped with a 16-pin LEMO connector for Powerl application.Ink technology.

Olympus utilizes a metal conductivity measurement and certification system, employing a four-point DC resistance technique for primary standard test blocks. These standard test blocks are continually maintained by Olympus and periodically re-certified to comply with NIST traceability. The primary standard test blocks and test samples are stored in an environment of 20℃ (+/-10℃), and the test samples are measured using the AC impedance transfer method. The entire system is computer-controlled to ensure accuracy and reproducibility.

Utilizing this primary standard test block technology, Olympus can provide high-accuracy certification for conductivity standard test blocks. The certification tolerance for materials below 60% IACS is 0.35% IACS or better, while for materials above 60% IACS, the certification tolerance is 0.5% IACS or better.

Incompatible with the basic model of NORTEC 600 instruments; requires the use of NORTEC 600C, 600S, or 600D models to complete the operation.

Also compatible with NORTEC 500 series and 2000 series.

Probe Technical Specifications

Conductivity Test Block Technical Specifications