| CYG1140 Osmotic Pressure Transmitter |
High-frequency dynamic design Diverse structural formats Overall temperature supplement, stable performance |
 |
| CYG1140Osmotic Pressure Transmitters (Pore Water Pressure Transmitters) are primarily used to test the internal pore water pressure or osmotic pressure in dam rehabilitation structures, enabling the understanding of geological water flow conditions. They are widely applied in areas such as the foundations of hydraulic structures, retaining wall tunnels, and underground engineering. |
 |
Range:0-1KPa…100MPa Type of Pressure: Gauge Pressure Sealed Gauge Pressure Please provide the Chinese content to be translated. Degree:±0.25%FS(Minimum) ±0.5%FS（Max. Long-term stability: ≤0.25%FS/Year ≤0.5%FS/Year Supply Voltage Range: ±9～24）VDC （9～24）VDC Signal Output:0/1～5/10V Pressure Interface:M5 M6 M8 M10 Ø5 Ø6 Ø8 Ø10 Ø8 Ø8Customer-Specified Compensation Temperature:-10℃～+60℃， Operating Temperature:-30℃～+80℃ Storage Temperature:-30℃～+85℃ Measurement Medium: Non-corrosive fluid for stainless steel and silicon materials Ingress Protection Rating:IP68 |
 |
Image1 M5/M6-10 |
Image2 Ø5/Ø6-16 |
Image3 Ø8-12 |
Image4 Ø8/Ø10-10 |
Image5 Ø8-20Sealed groove |
Image6 Ø10-M8X1 |
Image7 M8/M10-11 |
 |
 |
|
| Please fully immerse the pore water transmitter in water prior to burial.30Minutes, then place it into the test hole (keep the time as short as possible to avoid air entry). Cover the transmitter with sand around it, and seal the top with mud blocks, and it's ready for use. |
 |
1. Please specify the power supply requirements based on your actual needs during the selection process; for specific questions, please communicate with our technical staff. 2. Please indicate the required wire length on the order form. 3. If the customer has special requirements for other product features, please contact the supplier and note it in the contract. |
 |
CYG1140 Osmotic Pressure Transmitter
