Log inGrooved wagonWave BoxAd Image Installation
A full-body vehicle advertisement requires coordination across various stages: design, production, approval, and installation. Each step is crucial.
Slot car dimensions measurement
Advertising surfaces like truck trailers or container bodies require a different measurement method than standard trailers. Here are a few steps summarized:
Share as follows:FeiLing Vehicle Advertising Service
Firstly, measure and record the flat diameter of the vehicle body compartment that requires the advertisement.
2. Measure and record the diameters of the convex and concave surfaces.
3. Measure the length of the concave and convex surfaces.
4. Subtract the length of the concave-convex surface from its diameter to obtain a difference and record it.
5、MeasurementCount the total number of grooves, multiply the quantity by the difference, and add the diameter of the carriage flat to determine the actual dimensions of the truck trailer for the advertisement. If you're unclear, please refer to the image below:
Caution Before Posting Advertising Billboards/Feilin Vehicle Advertising Service
Firstly, if it's a newly purchased truck, the body must be cleaned and wiped down before installing the body decals; if it has previously had painted graphics applied, the old graphics must be peeled off.
Additionally, it's important to note that some old graphics have been in use for an extended period and are prone to having localized residue. This residue must be thoroughly cleaned with gasoline; otherwise, the new car sticker's adhesive will not securely bond to the old sticker's residue. It won't take a day for bubbles to form, and during rain, it will naturally result in water bubbles.
Slot car advertisement poster pasting method/Feilin Vehicle Advertising Service
How is the advertising image applied to the grooved wagon?
Similar to the body of the vehicle in the above illustration, just stick the decals on.About 5 steps.
Be ready with tools:Scissors, two rags, two personnel, one ladder.FeiLing Vehicle Advertising Services
1. Clean the car body, as it's inevitable to accumulate a lot of dust while driving on the road. Keeping it clean will result in a better effect and increased durability.
2. Rip a piece about 20cm wide from one end, starting at the beginning, and first scrape it on the carriage. Then, position it all around the body of the vehicle.Rear of the vehicleSet the location.
3. Then, slowly roll it up from the rear, making the roll as small as possible for ease in pulling the bottom paper.
4. Roll to the starting point, and the two people slowly pull the backing paper apart, about 40 cm. Then, both simultaneously use a scraper to gently lift the paper from the middle upwards and downwards. Ensure a smooth pass along the groove edge without tearing. If torn, the image will become elongated, making it harder to apply. Practice makes perfect, and with more attempts, the technique will become natural and proficient.
5. Finishing touches: Trim any necessary parts with an artist's knife, and deal with any bubbles as well. A hot air gun or lighter can also be used.
Note that attention should be paid to the dimensions from the start, adding an extra 10% to the total length from the flat ruler. For materials, always use black backing vehicle stickers. The difficulty will be significantly greater with standard stickers.
Note:Do not use dishwashing liquid during the application process; apply dry.
