ZN-C型新型浓缩罐

ZN-C型新型浓缩罐

产品概述/Product overview

       1、ZN-C型是加长筒体分离段；

       2、为克服浓缩權顶二次蒸汽在末进入冷凝器前被冷疑而返回罐内的缺点。本设备将冷凝器改为斜卧式；

       3、为提高设备的生产能力，本设备将浓缩罐夹套的加热面积，冷凝、冷却器的面积均有不同程度加大；

       4、为防止浓缩罐出液管的死角，本产品中采用不锈钢球形考克；

       5、在浓缩罐下部设置了快开式手孔，以使清理罐内残液，残渣；

       6、ZN-C型是将加热夹套分两段或三段，当液面低时关必闭上段加热防止干壁。其底改为锥底便于排尽浓缩液。

       1.ZN-C type is separation section of extended cylinder body.

       2.The condenser of this equipment is of inclined type in order to overcome disadvantages of secondary steam condensation and flowing back to the concentrator before entering the condenser.

       3.In order to improve production ability, heating area of jacket of the concentrator, area of condenser and cooler has been increased with different degrees.

       4.Stainless steel ball cock is used to prevent dead corner in liquid outlet pipe of the concentrator.

       5.Quick-open hand hole is set at lower part of the concentrator to clear residual liquid and slag inside the concentrator.

       6.The ZN-C type divides the heating jacket into two or three sections. When the liquid level is low, the upper section shall be heated to prevent dry wall forming. The bottom part shall be replaced with cone-shaped bottom to make it easier for concentration liquid discharging.

主要技术参数参考表/Reference table of main technical parameters