FSP7 Rod Spectrum Analyzer 7GHz

FSP7 is R&S's 7 GHz Spectrum Analyzer. Spectrum analyzers measure the power spectrum of known and unknown signals. They collect information such as the amplitude of the input signal relative to its frequency.

As a frequency analyzer, the primary use of a spectrum analyzer is to record and analyze the spectral components of electrical input signals and other signals.

Frequency Range: 9 kHz to 7 GHz

Resolution Bandwidth: 1 Hz to 10 MHz

Average Noise Level Displayed: -155 dBm (1 Hz)

Phase noise: -113 dB (1 Hz) at 10 kHz

Additional Filters: Channel filters from 100 Hz to 5 MHz, RRC filters, FFT filters from 1 Hz to 30 kHz, EMI bandwidth, and quasi-peak detectors

TOI, MC ACP(R), OBW, CCDF, APD, etc., measurement functions

Cellular standards and general measurement applications, such as phase noise, noise figure, etc.

DANL Typical Value: -155 dBm (1 Hz) No Pre-Amplifier

Phase noise typical value: -113 dBc/Hz @ 10 kHz offset, CF 500 MHz

Typical phase noise value: -145 dBc/Hz at 10 MHz offset, CF 500 MHz

TOI Typical Value: 10 dBm

1-dB Compression Point: 0 dBm

0.5 dB Total Level Uncertainty up to 3.6 GHz

Lowest linear error as low as <0.2 dB, down to -70 dB

12-bit Digital Medium Frequency Meter, 32 MHz (20.4 MHz IF)

2x128k samples IQ memory

The frequency domain scan time is 2.5ms

Time-domain scan duration: 1 μs

Up to 70 remote measurements per second via GPIB

Up to 80 manual measurements per second (screen refresh)

Supported Technologies