FT-103D Angle of Repose/Retraction Angle Tester for Bulk Materials, Dynamic Retraction Angle

FT-103D Angle of Repose/Retraction Angle Tester for Bulk Materials, Dynamic Retraction Angle

Reference Standard:

JB/T 9014.7—1999Continuous conveying equipment; determination of the angle of repose for bulk materialsZB  J8 1  006.7—88 "Determination of Angle of Repose for Bulk Materials in Continuous Conveying Equipment"

Two.Application Scope:

The standard specifies the method for determining the angle of repose of bulk materials; applicable to the particle size conveyed by continuous conveying equipment. 0~50mmNatural and dynamic angle of repose determination for granular materials.

Three.Principle:

Under specified test conditions, determine the natural and dynamic angle of repose of the material for evaluating its flowability.Please provide the Chinese content you would like translated into American English.Grade and calculate the internal friction coefficient of materials.

Four.Parameter Requirements:

Particle size less than6mm Materials are measured using an angle of repose and stop angle gauge.

Vibration Platform: Uses magnetic vibration method; Amplitude is0.5mmFrequency:0-250Hz

Stacked Sheets: Diameteriameter1M

Cut-off port distance from the flat surface250mmAdjustable; feed opening diameter50mmBushing inner diameter:300mm

Barrel export with control valve

6.Timer:0-9999H/M/S

 Timer: 0-9999H/M/S

7.Configuration Tools: Calipers, Protractor, Material Trays, Shovels, Rakes, Metal Rule, Bristle Brush, Wire Brush

8. Particle size greater than6mm The material is measured using manual stacking methods.

9.Input:220v