Repositioning Services

1. Place the refrigerator on a level surface and remove the packaging base to minimize vibration and noise. When moving, ensure the tilt angle does not exceed 45 degrees.

2. Ensure there is adequate space between the refrigerator and adjacent items for proper ventilation and heat dissipation.

Refrigerators should be placed in areas not exposed to direct sunlight and away from heat sources.

Do not place it in areas with high humidity or where water splashes easily.

Do not place in environments too cold to freeze.

After moving the refrigerator, wait 30 minutes before plugging it in.

Regulate operations

Power On: The green indicator light illuminates to indicate that the power is on, and the refrigerator has entered the working state.

2. Temperature Control: The storage temperature of the refrigerator is adjusted by the internal thermostat. The thermostat should be adjusted according to the ambient temperature and the specific conditions of the food stored in the refrigerator. In summer, it is advisable to decrease the temperature setting (by turning the thermostat knob counterclockwise), as the temperature setting is usually pre-set upon the refrigerator's manufacture and should not be frequently adjusted during regular use. Avoid touching any other parts of the refrigerator while adjusting the thermostat knob.

3. Trial Run: Power on the refrigerator for a trial run. If a noticeable cooling effect is felt after half an hour, it indicates the refrigerator is operating normally. After the empty refrigerator has run for a period (6 hours in summer, 4 hours in winter), frozen food can then be stored inside.

Safety Precautions

1. Refrigerators must be equipped with a separate three-prong outlet and an appropriate fuse rated at 5A. Do not use a multi-outlet adapter.

2. If the voltage is unstable or falls outside the range of 187V-242V, an appropriate automatic voltage stabilizer should be installed.

Defrosting: After a period of use, frost may form inside the refrigerator. If the frost becomes too thick, it can affect the refrigerator's cooling performance and increase its power consumption. Therefore, defrosting should be performed at intervals when the frost layer reaches about 5 millimeters, using a plastic scraper.

2. When defrosting, turn off the power, remove the items for insulation, and place them in a cool area. To speed up the defrosting process, you can put a flat-bottomed pot filled with hot water inside the cabinet.

After the frost layer has been completely melted, dry the refrigerator with a clean cloth and then plug it in to continue using.

4. Cleaning: Please unplug the power cord for safety before cleaning.

5. When cleaning refrigerators, please use a soft cloth or sponge, dampened with water or soap (non-corrosive neutral cleaners are also acceptable). After cleaning, wipe dry with a dry cloth to prevent rust. When cleaning thermostats and other electrical appliances, please wring out the cloth before use.

6. Regularly clean the condenser, compressor, and dust filter inside the machine room with a soft bristle brush to maintain optimal cooling performance.

7. Discontinuation of Use: For a prolonged period of non-use, the refrigerator should have its power supply disconnected and cleaned according to the aforementioned instructions. After opening the lid to allow it to air dry, seal it properly.

Do not discontinue use in most cases, as it may affect the lifespan of the refrigerator.

User Instructions:

1. After plugging in, the red light illuminates and the compressor starts. After about ten minutes, the temperature display indicates that the refrigerator is operating normally. Turning the temperature control knob clockwise, the temperature gradually decreases. When it reaches a certain low temperature, the machine shuts off, at which point the green light turns on and the red light turns off. 2. If there is too much food, the refrigerator can operate intermittently. Do not allow the compressor to work for a long time. Simply turn it off manually after the food is quickly frozen.

3. When loading food into crates, leave gaps between the top, bottom, and sides for air circulation, as this not only saves electricity but also prolongs the lifespan of the compressor.