Each friction point's measurement allows for precise demand, but compared to oil mist lubrication, consumption is reduced by about 90%; fog-free, breathing fresh air; a drop of oil is drawn into stripes by the airflow in a narrow tube.

Then, transport it along the lubrication points. Continuously supply oil droplets to the bearings from the outlet nozzle. The carrier gas generally does not allow oil to leave the bearings. Main applications are in the field of mechanical engineering, where there is a high requirement for lubrication definition: low wear and long service life. It is necessary to increase the rotational speed of the spindle and shaft on the rolling bearings beyond the values referenced in the rolling bearing catalog, such as bearings, to increase cutting speed. Grinding and milling spindles.

To meet this requirement, not only is the design of the bearing components crucial, but selecting a good lubrication system is also essential (e.g., standards, bearing types, etc.). Piping, such as 4×0.85 flexible plastic pipes, can be installed, allowing for easy visual observation of oil transport to facilitate its rise or fall. The short length of the line is 1 m, while the total line length is 10 m.

If the distance between the equipment and the bearing point is less than 1 meter, the oil-gas lubrication system requires the line to be arranged as a spiral coil. For longer lines, it is recommended to use a spiral coil with approximately 5 turns to place the feed pipe as close to the bearing point as possible. The center axis of the coil should be horizontal or at an angle.