Industrial ovens are constructed with angle steel and thin steel plates, with additional reinforcement for the cabinet, coated with paint on the exterior. The shell and inner lining are filled with aluminum silicate fiber to form a reliable insulation layer. Industrial ovens can dry various industrial materials and are a universal drying equipment. What is the emergency procedure for damaged accessories in industrial ovens? Below, the Xinhua Automation editor introduces this issue to you.
1. The switching device failed.
Check if the switch toggle and shaft are slipping; if so, simply tighten the toggle fixing screw without the need for replacement. However, if the fatigue of the switch's copper contact strip has caused it to lose elasticity, a new strip should be replaced.
2. The indicator light is not illuminated.
The reasons for the indicator light not illuminating may include a burnt-out filament, loose connections between the neon bulb and the current-limiting resistor, or a burnt-out current-limiting resistor. Investigate these issues one by one, replace the indicator light, resolder the disconnected points from scratch, and then, based on the situation, replace the current-limiting resistor to resolve the problem.
3. The temperature control thermostat has failed.
Inspect the temperature control thermostat's knob, shaft thread sleeve, contacts, and ceramic beads of the bimetallic strip. If the shaft slips, tighten the screws; if the shaft thread sleeve rolls with the shaft, secure the thread sleeve; if the contacts are fused, replace the contacts; if the ceramic beads are broken or fall off, replace with new ones.
In summary, this article outlines the emergency response for industrial oven component damage. We hope this information is helpful to you. For more details about industrial ovens, welcome to Xin Hua Automation, where our professionals are ready to assist you.
