P珍珠 Rock Paneling is a decorative material that is widely used in interior design due to its lightweight, eco-friendly, and easy-to-install properties. Below are the installation steps for Pearl Rock Panels introduced by the Qiqihar Pearl Rock Factory for you.

Step One: Preparation

Firstly, prepare the wall where the perlite panels will be installed. Ensure the wall is flat, dry, and clean, with no uneven areas. If there are cracks or uneven spots, they should be repaired or treated.

Step Two: Measure Dimensions

Measure the wall dimensions using a ruler and protractor. Based on the measurements, devise an installation plan, determining the size and quantity of the perlite panel.

Step Three: Groove Cutting

Based on the measurement results, slots should be cut into the wall. The depth and width of the slots must be determined by the thickness and dimensions of the perlite board. Slot cutting can be done using tools like an electric hammer.

Step Four: Install the Back Frame

In the areas where wall grooves are made, install the back frame for perlite suspended panels. The back frame can be made from wooden strips or other materials and securely fastened to the wall.