The hydrogenation step of the blender is quite particular; understanding the process is crucial when in use.

1. Check that all valves on the mixer are tightly closed and direct the exhaust hose to an open area with good air circulation.

2. Install the hydrogen gas pressure-reducing valve and nitrogen gas pressure valve, and after installation, check for leaks using soap and water.

Extract air from above the liquid surface at the exhaust port using a vacuum.

4. Open the mixer's air inlet valve, then open the nitrogen pressure-reducing valve and fill with nitrogen. After achieving the internal kettle pressure, close the nitrogen valve, the pressure-reducing valve, and the air inlet valve. Maintain for about two minutes to observe if the pressure gauge shows a decrease. Additionally, bend down and listen for any leaks from the valves and kettle cover. If no leaks are detected, slowly open the exhaust valve to expel the internal pressure to 0.01 Mpa, then close the exhaust valve. Repeat this step once more.

Step 5: Open the intake valve, activate the hydrogen pressure reducing valve, fill with hydrogen to the desired pressure, close the intake valve, close the hydrogen pressure reducing valve, then adjust the stirrer's other parameters to the required state for the reaction.

The hydrogenation step of the mixer is simple, highly versatile, and more suitable for your selection. Welcome new and old customers to choose our products.