Structural principle and characteristics of Chuzhou BMD pulse flat bag dust collector

Product Introduction of Chuzhou BMD Pulse Flat Bag Dust Collector

BMD type for industrial workshopsbag filterIt is a pulse flat bag dust collector designed and produced by Shiheng Environmental Protection based on the advantages of similar products at home and abroad. The bag filter is usually used to collect non cohesive, non fibrous industrial dust and volatile matter. In industrial dust treatment, it can capture particles up to 0.1 micron dust. The BMD pulse flat bag filter has a high purification efficiency, that is, it can capture fine dust up to 99%. Below, we will introduce the structural principle and characteristics of the BMD pulse flat bag dust collector.

The design structure principle of BMD pulse flat bag dust collector:

The design structure of the Shiheng BMD pulse flat bag dust collector is a split chamber outer counter blowing flat bag dust collectorbag filterIt is a new variety of pulse bag dust collector. The Shiheng BMD pulse flat bag dust collector adopts a pulse back blowing system. Compared with mechanical vibration cleaning or low-pressure back blowing cleaning, this method has much better dust cleaning effect and no moving components, which can greatly reduce maintenance workload. The complete system of the Shiheng BMD bag filter includes a clean air box, a dust air box, an ash hopper, a blowing device, and a bracket. There is a spray pipe installed in the clean air box, and the clean air section has a clean air outlet. In front of it is a maintenance door. When the maintenance door is opened, it is easy to replace any dust filter bag. In the dust and air section, the dust and air inlet is located at the upper part of the air box, and a filter bag is installed inside the box. In the ash hopper section, dust enters the dust box, while clean air is filtered through an empty filter bag to clean the air box. The dust is about to settle into the ash hopper, and the settling direction is consistent with the airflow direction, which is conducive to the settling of dust. A partition is installed between the clean air box and the dust air box, and the general filter bag configuration size is a rectangular flat filter bag with a length of 1200mm, a width of 480mm, and a thickness of 26mm. The anti blowing device is installed under the clean air box, including an air bag, pulse valve, pulse controller, etc. For more bag filters, please follow our website http://www.btshhb.com