I. Equipment Overview
The fully automatic water softener features include: automatic softening process, automatic regeneration process, and automatic cleaning process. The softener requires an electrical control box, with the entire operation process being monitored by an electrical contact pressure gauge that feeds signals back to the control box. The control box then precisely controls the opening and closing of valves to achieve automatic control. In the event of a fault during the automatic operation, manual control can be used.
Section II: Equipment Performance Requirements
1. Power Consumption:<10W；
2. Ease of Management: No specialized knowledge required for the user; all management consists of simply adding salt periodically.
3. Continuous Outflow: All dual-vessel systems, one in use and one in reserve, for 24/7 operation.24Continuous output for hours
4. Flow control: Ensure reliable operation;
5. Reverse Osmosis Reclamation: Utilizes reverse osmosis process with softened water for both reclamation and reverse osmosis.
6. Simple maintenance: Low failure rate.
Section 3: Softener Design Parameters
1. Original Water Hardness:3-10mg-N/L（1mg-N/L=2.8German Degree=50mg/LCaCO3Hardness);2. Outflow Port Hardness: ≤0.03 mg-N/L；
3. Outlet Pressure:0.2Mpa；
4. Operating Temperature:2-50℃；
5. Self-powered supply220V，50Hz；
6. Medium: Tap water
7. Rated Flow Rate:8t/h；
8. Resin Model:001×7Strong Acid Cation Resin
9. Equipment dimensions do not exceed2.2×0.7×2.2(High)mBasic conditions are shown in the attached figure.
IV. Control Requirements
The system can automatically achieve water softening, adjust resin regeneration and cleaning based on water quality, emit an alarm signal in case of equipment failure, and transmit it remotely to the central control room.DCSSystem.
V. Inspection Standards, Acceptance Standards, and Acceptance MethodsResin exchange agent acceptance procedureGB/T13659-98Standard Compliance.
Section 6: Product Range
Multi-way control valve1set, controller1Piece (Artus or)FLECK), Tank Exchange2Unit, Automatic Salt Water Valve2Kit, Salt Absorber Tube2Piece, top and bottom water distributors2Kit, solenoid valve2Piece, Pressure Gauge2Piece, Pipeline1Packs, exchange resin, with automatic backflush/Automatic regeneration control device, the selection of resin for exchange possesses excellent physical stability and resistance to chemical degradation, quantity not less than200kg。
Section 7: Shipping and Installation Requirements
Suppliers are responsible for delivering the water softener to the installation site. They should provide all necessary flange or threaded connection parts, as well as the required accessories (nuts, bolts, washers, etc.) for installation.
Section 8: Documents and Services Provided
1.Suppliers provide product inspection certification documents.
2.Equipment and accessories user manual (or handbook)12Sets, equipment exterior dimensions, piping diagrams, etc. drawings12Set, electronic version1Piece.
3.Contract executed5Please provide the equipment's exterior drawing for review within the day, clearly indicating the cable connection port locations; the file format for communication during the manufacturing process is: drawings forAutoCADText remainsWORDFormat.
4.Provide on-site guidance for installation and debugging services based on the project progress.
