The metal trough distributor is composed of rectangular riser pipes, angle irons, trough-shaped liquid guide pipes, dovetail or trough-shaped liquid stoppers, deck plates, support rings, and support beams. The main difference from the disk-type liquid distributor lies in the two rows of small holes, which are larger at the top and smaller at the bottom, respectively, and are located at the top, middle, or lower middle of the rectangular riser pipes. The unequal diameter small holes on the same vertical line are covered by angle iron or trough-shaped liquid guide pipes.
Metal槽盘distributorTo minimize the amplification effect caused by poor liquid distribution and to fully utilize the efficiency of the packing material, a liquid distributor must be installed in the packing tower to evenly distribute the liquid over the top of the packing layer. The quality of the initial liquid distribution not only affects the mass transfer efficiency of the packing but also influences the operational flexibility. Therefore, the liquid distributor is an extremely critical internal component within the packing tower. There are many types of distributors, and the selection is primarily based on factors such as distribution quality, operational flexibility, treatment capacity, gas resistance, and levelness, among others.
Distributor differentiation: 1.Distributed by shape: Tubular, Double-layer Tubular, Groove-type, Disc-type, Impingement-type, Jet-type, Pyramidal-type, Lily-type, Combination-type, etc. 2. Distributed by the liquid's exit form from the distributor: Hole flow type, Overflow type. 3. Distributed by the number of liquid distribution: Single stage, Multi-stage. 4. Distributed by the combination method of the distributor: Tubular groove type, Hole groove type, Groove disc type. 5. Distributed by the fluid dynamic of the distributor: Gravity type liquid distributor (hole type, weir type, pressure type liquid distributor, spray type, porous pipe type).
Tower internals: vapor-liquid separator demisters, mist collectors, liquid collectors, Teflon distributors, weir demisters, spray nozzles, packing grids, liquid redistributors, tray-type liquid distributors, ammonia water filters, camelback supports, packing supports, tube-type liquid distributors, mesh demisters, tower internal connectors, PVC distributors, plastic weir mist collectors, bubble caps, inlet tubes, floating valve trays, Johnson mesh piping, circular bubble caps, ceramic distributors, removable tray-type gas-liquid distributors, packing grids, etc.
Note: Non-standard tower internals can be manufactured according to customer-provided drawings, and tower internals can be designed, manufactured, and installed based on customer-provided parameters. We have hired several doctoral graduates from various universities to serve as technical advisors at our factory, forming a technical department to provide you with professional technical services.
