Company specializes in: Demolition, repair, reinforcement, anti-corrosion, beautification, installation, painting of aviation marks, color rings, painting, and coating, etc., for all types of chimney water towers and high-altitude engineering projects. Construction is safe, quick, technically proficient, affordable, and诚信守约. We sincerely look forward to partnering for mutual success!

Chimney painting and coating, as well as beautification of beacon color rings, typically involve two methods of operation, both requiring high-altitude climbing: ascending to the top of the chimney or a platform, then proceeding with either (1) high-altitude suspended rope work or (2) installation of a high-altitude basket.

Key Safety Points for High-altitude Anti-corrosion Construction Work

Chimney corrosion prevention construction requires familiarity with the professional technology of this trade and all safety regulations.

2. Must be 18 years or older and pass a physical examination to perform高空作业. Individuals with high blood pressure, heart disease, epilepsy, and other conditions unsuitable for high-altitude work are prohibited from engaging in climbing work.

3. Above 2 meters from the ground, with an incline angle greater than 45 degrees on the working slope, or if the working surface lacks a stable standing place or is prone to vibration, it should be considered as high-altitude work.

4. Protective gear must be worn properly, pants legs should be tucked in, a hard hat must be worn, and smooth-soled shoes are not allowed. A safety belt of sufficient strength is required, and the rope should be tied to a solid building structure or metal framework; it must not be tied to any moving objects.

Before climbing, the construction supervisor must conduct on-site safety training for all personnel.

6. Inspect all climbing equipment and safety gear (such as helmets, safety belts, ladders, planks, scaffolding, guardrails, safety nets, etc.) to ensure they are safe and reliable. Absolutely no risky operations are permitted.

7. Mark off the restricted area on the ground in the high-altitude work zone and hang up warning signs such as "No Trespassing" and "Access Prohibited."

8. Prior to working near power (low voltage) lines, contact for power outage first. Work can only be performed after confirming the outage, and insulating barriers should be set up. Workers must remain at least 2 meters away from the power lines (low voltage) and it is prohibited to work under high voltage lines.

9. Tools, parts, and materials used for high-altitude chimney anti-corrosion work must be stored in tool bags. When ascending or descending, no items should be held in hand, and movement must be along designated routes; materials or tools should not be thrown from height. Do not stack items that are prone to roll or slide on scaffolding, and avoid disorganization. After completing the work, promptly clean up all items that could fall, such as tools, materials, and parts, to prevent injury. When handling large components, use reliable lifting equipment.

10. Always be aware of hazard signs and areas. Adequate lighting must be provided for night operations; otherwise, construction is prohibited.

11. Absolutely prohibit simultaneous vertical work at both levels. In case of special circumstances requiring vertical work, approval from relevant leaders is required, and protective sheds or other isolation facilities must be set up between the two levels.

Do not rest in high places without barriers to prevent falls.

13. Plywoods over 3m in length cannot accommodate two persons working simultaneously.

14. Walkways, ramp boards, gangways, and transportation paths should be kept clean at all times.

15. No overhead work is allowed outdoors when wind speeds exceed grade 6.