High and Low Temperature Shock Test Chamber

One,Meets Standards:

u  GB2423.22 Temperature Variation Test, Test N

u  GB2423.1-89 Basic Test Procedures for Electrical and Electronic Products: Test A: Low Temperature Test Method

u  GB2423.2-89 Basic Test Procedures for Electrical and Electronic Products: Test B: High-Temperature Testing Method

u  GB/T 2423.1 Electrical and Electronic Products Environmental Testing Part 2: Test Methods Test A: Low Temperature

u  GB/T 2423.2 Electrical and Electronic Products Environmental Testing - Part 2: Test Methods - Test B: High Temperature

u  GB/T 2423.22 Electrical and Electronic Products Environmental Testing Part 2: Test Methods Test N: Temperature Change

u  GB/T 5170.2 Environmental Test Equipment for Electrical and Electronic Products - Inspection Methods: Temperature Test Equipment

II. Technical Specifications:

1Temperature Range: -20℃/-40℃/-55℃/-65℃ to +150℃

2High and low temperature zone temperature range: High temperature zone +60℃～+200℃

Low Temperature Zone 0℃～－70℃

3Temperature Exposure Range: High-Temperature Test Zone +60℃～+150℃

Low-Temperature Test Area 0℃～-40℃

4Temperature Limit: +200℃

5Minimum Temperature: -75℃

6Temperature Deviation: ±2℃

7Temperature Fluctuation: ±0.5℃

8Recovery Time to Temperature: 5 mins

9Recovery Temperature Conditions: 3-5 minutes

10Sample transfer method: Pneumatic

11Power: AC380V±10% / 50/60Hz + protective grounding

Section 3: Model and Inner Box Dimensions (W x H x D)

ZT-30A-S300mm W x 350mm H x 300mm D

ZT-50A-S350mm W x 400mm H x 350mm D

ZT-80A-SW 400mm x H 500mm x D 400mm

ZT-150A-SW 500mm x H 600mm x D 500mm

ZT-252A-S      W60"W x 70"H x 60"D

4. Equipment Structure:

1Test Chamber Structure: The test chamber is designed with an integrated modular structure, where the test chamber is composed of a high-temperature testing section located at the lower rear.

    Box, the low-temperature test chamber located at the upper rear, the refrigeration unit cabinet at the rear, and the electrical control cabinet on the left rear panel

   The system is composed of this method of cabinet, which occupies less floor space, features a compact structure, and an aesthetically pleasing appearance. The refrigeration unit is housed in an independent unit box.

    Within the body.

2Outer material of the box: Electrostatically dissipative spray-painted varnished cold-rolled steel plate/SUS304 stainless steel plate

3Material inside the box: SUS304 stainless steel plate

4Insulation Materials: Rigid Polyurethane Foam, Grade 1

5Cable entry holes: Sliding cable entry conduits are installed at the top of the sample rack and the top of the high-temperature test chamber.

6Sample Rack Load Capacity: ≥3Kg.