Japan Magnescale Digital Indicator LH70-2
High-performance counters for milling and turning applications
Milling and turning counter
Display Resolution Switch
Machine Error Compensation
Data Storage
Reset/Default
Origin Measurement Component Calibration
Programming Functionality
Multiple basis points
Milling Machine Features (Bolt Hole Perimeter / Simple R-Profile Machining / Linear Holes)
Lathe Specifications (Tool Coordinate / Accumulation Function)
| Main Specifications | |||
|---|---|---|---|
| Model | LH70-1 | LH70-2 | LH70-3 |
| Display | Display 7 digits and negative numbers | ||
| Connectable measurement component | GB-ER, PL20C, SJ700A (Direct)/DG-B ( Requires additional conversion adapter) | ||
| Measurement Component Input Resolution | Standard: 0.1μm, 0.5μm, 1μm, 5μm, 10μm, 1s, 10s, 1min, 10min Expansion: 100μm, 50μm, 25μm, 20μm, 2μm, 0.05μm; can add 1 degree | ||
| Display Resolution | Measurement component input resolution or higher, and its double display (except for angle display) | ||
| Input Signal | A/B phase (pulsed) signal, Z phase (conforms to EIA-422) | ||
| Small phase difference | 100ns | ||
| Quantized error | ±1 count | ||
| Alert displayed | Length measuring component not connected, overspeed, exceeded large display limit, power failure, error saving data | ||
| Reset | Reset via push-button switch | ||
| Pre-set | Save/Access 3 types of values | ||
| Origin Detection Function | Origin detection for length measuring component | ||
| Data Storage | Preserve display values and various settings during power failure | ||
| Linear Compensation | Compensate the count value for the length measuring component by a certain amount. Compensation Quantity Standard: ±600um/m (Extended: ±1000um/m) | ||
| Programming |
| ||
| Dormant | If no action is taken within a specified time frame, the display will disappear (the time can be set). | ||
| Power Supply | DC 12V, rated 0.75A, max. 1A, AC 100-240V ±10% When using the AC adapter PSC-23A (suitable for Europe and other countries) *Optional | ||
| Power Consumption | Max. 32VA (Connected to AC adapter) | ||
| Operating Temperature Range | 0 to 40°C (No condensation) | ||
| Storage Temperature Range | -20 to 60°C (No condensation allowed) | ||
| Quality | Approximately 1.5 kg | ||
| When selecting the LH70 general application or milling machine specifications (set to "general" in the basic model selection mode) | |||
|---|---|---|---|
| Model | LH70-1 | LH70-2 | LH70-3 |
| Display shaft | 1 shaft | 2-axis | 3-axis |
| Multiple benchmark points | 10 | ||
| Bolt hole circumference | – | Show coordinates for evenly spaced holes on a circle of diameter | |
| Simple R Processing | – | Display the coordinates of the simple R processing point | |
| Threaded hole | – | Coordinates for evenly spaced drilling along the line | |
| When selecting the LH70 lathe specifications (set "lathe" in the basic model selection mode) | |||
|---|---|---|---|
Magnescale reserves the right to modify product specifications without prior notice. | |||
| Model | LH70-3 | ||
| Display shaft | 2-axis display (2-axis or 3-axis input) | ||
| Tool Positioning | 12 | ||
| Measurement component input addition 2 | It features 2-axis addition display. | ||
| Maintain display visibility | Maintain display value and input tool coordinates | ||
