Japan Magnescale Digital Indicator LH70-3
High-performance counters for milling and turning applications
Milling and lathe counters
Display Resolution Switch
Machine Error Compensation
Data Storage
Reset/Default
Original Point Measurement Component Calibration
Programming Features
Multiple benchmark points
Milling Machine Features (Bolt Hole Perimeter / Simple R Profiling / Linear Holes)
Lathe Specifications (Tool Coordinate / Accumulation Function)
| Key Specifications | |||
|---|---|---|---|
| Model | LH70-1 | LH70-2 | LH70-3 |
| Display | Display 7-digit numbers and negatives | ||
| Connectable measurement component | GB-ER, PL20C, SJ700A (Direct) / DG-B ( Requires an additional conversion adapter) | ||
| Measurement Component Input Resolution | Standard: 0.1μm, 0.5μm, 1μm, 5μm, 10μm, 1s, 10s, 1min, 10min Expansion: 100μm, 50μm, 25μm, 20μm, 2μm, 0.05μm; can add 1 degree | ||
| Display Resolution | Measurement component input resolution or higher, including double display (except angle display) | ||
| Input Signal | A/B phase (pulsed) signal, Z phase (conforming to EIA-422) | ||
| Small input phase difference | 100ns | ||
| Quantized error | ±1 count | ||
| Alert displayed | Length measuring component not connected, overspeed, exceeded large display limit, power failure, error saving data | ||
| Reset | Reset via push-button switch | ||
| Pre-set | Save/Call 3 Types of Values | ||
| Origin Detection Function | Origin detection for length measurement component | ||
| Data Storage | Preserve display values and various settings during power outages | ||
| Linear Compensation | Compensate the count value for the length measuring component by a certain amount. Compensation Quantity Standard: ±600um/m (Extended: ±1000um/m) | ||
| Programming |
| ||
| Sleep Mode | If there is no activity within a specified time frame, the display will disappear (time can be set). | ||
| Power Supply | DC 12V, rated 0.75A, max. 1A, AC 100～240V ±10% When using the AC adapter PSC-23A (for Europe and other countries) *Optional | ||
| Power Consumption | Max. 32VA (Connected to AC adapter) | ||
| Operating Temperature Range | 0 ~ 40°C (No condensation allowed) | ||
| Temperature Range for Storage | -20 to 60°C (No condensation allowed) | ||
| Quality | Approximately 1.5 kg | ||
| Choose LH70 General Application or Milling Machine specification (set to "general" in the basic model selection mode) | |||
|---|---|---|---|
| Model | LH70-1 | LH70-2 | LH70-3 |
| Axle Display | 1 shaft | 2 shafts | 3-axis |
| Multiple benchmark points | 10 | ||
| Bolt hole circumference | – | Display coordinates for drilling holes at equal intervals on a circle with a given diameter. | |
| Simple R-Processing | – | Display coordinates of simple R processing points | |
| Threaded hole | – | Show coordinates for evenly spaced drilling on the line | |
| Choose the LH70 lathe specifications (set "lathe" in the basic model selection mode) | |||
|---|---|---|---|
Magnescale reserves the right to change product specifications without prior notice. | |||
| Model | LH70-3 | ||
| Display shaft | 2-axis display (2-axis or 3-axis input) | ||
| Tool Positioning | 12 | ||
| Measurement Component Input Addition 2 | It features 2-axis addition display. | ||
| Display Maintained | Maintain displayed value and input tool coordinates | ||
