The 600X electric control valve is a hydraulic-operated valve with an electromagnetic valve as the pilot, primarily used for remote control in water supply and drainage as well as industrial systems, and can replace gate valves and butterfly valves in large electric operating systems.

Structure and Function

This valve is composed of components such as the main valve, solenoid pilot valve, needle valve, ball valve, and filter. It is connected by flanges and features unidirectional flow. It is controlled by receiving an electrical signal through the solenoid pilot valve (supports AC220V or DC24V power supply) to open or close. The closing speed can be adjusted by the needle valve to avoid water hammer effect.

Technical Specifications

Nominal Diameter: DN20-DN600

‌Work Pressure: 1.0-2.5 MPa

Medium Temperature: 0-80℃

‌Valve Body Material: Cast Iron, Cast Steel, Stainless Steel

Seal Materials: Nitrile Rubber

Installation Method: Horizontal or Vertical Mounting (valve cover facing up when horizontal)

Application Scenarios

Suited for municipal water supply, high-rise building zone water supply, fire protection systems, and industrial automation control, including pump联动 protection and remote operation of wastewater treatment systems.

Installation and Maintenance

Install a Y-type filter before the valve and keep the drain outlet clear. A drainage device must be reserved for the fire protection system. The main valve diaphragm is a wear item that requires regular inspection and replacement.