1. Drilling reminds you not to let the water pump work if there are any minor malfunctions. If the packing of the water pump shaft is worn out, it should be added in a timely manner. Continuing to use the water pump will cause air leakage. The direct impact of this is an increase in motor energy consumption, which can damage the impeller.

2. Drilling reminds you that if the water pump experiences strong vibrations during use, you must stop and check the cause, otherwise it will also cause damage to the water pump.

3. When the bottom valve of the water pump leaks, some people will fill dry soil into the inlet pipe of the water pump and flush it with water to the bottom valve. This practice is really not advisable. Because when dry soil is placed into the inlet pipe and the water pump starts working, it will enter the pump and damage the impeller and bearings, which shortens the service life of the water pump. When the bottom valve leaks, it must be taken for repair. If it is serious, it needs to be replaced with a new one.

4. After using the water pump, it is necessary to pay attention to maintenance. For example, when the water pump is used up, the water in the pump should be drained, and the water pipe can be removed and rinsed with clean water.

5. Drilling reminds you to also remove the tape on the water pump, rinse it with water, and air dry it in a bright place. Do not place the tape in a dark and damp place. The tape of the water pump must not be stained with oil, and do not apply any sticky substances on the tape.

6. Drilling prompts you to carefully check whether there are cracks on the impeller, whether the impeller is fixed on the bearing for looseness. If there are cracks or looseness, they should be repaired in a timely manner. If there is soil on the impeller of the water pump, it should also be cleaned up.