Elevator Introduction:

Wanxin Transmissionscrew liftIt is a manufacturer of screw elevators, and since its establishment, the company has been committed to the research and development of transmission technology for screw elevators, especially the HK spiral screw elevator, which has its own characteristics.
1.HK spiral screw elevatorThe snail and wheel lift are used as accessories in machines and are made into a series of products that have become commercialized in the market and successfully promoted; And promote the application of the mechanical industry in component accessory assemblies, providing convenience and practicality in mechanical design;
2. HK spiral elevators and worm gear elevators have specifications ranging from HK-08T to HKT-150. The screw rod end can be divided into four types for application: flat mouth type, screw thread type, bolt hole type, and top plate type. It can be used in tension type or push type applications.
3. The HK spiral screw elevator and worm gear elevator have a simple structure, and the main components are: 1. The casing 2. The input worm shaft 3. The copper part worm gear with internal threads
4. Composed of other small attachments.
HK spiral elevators and worm gear elevators can be used for:
1. Elevating platform (can be started synchronously with multiple units connected in series).
2. It can be used to adjust the spacing structure of the roller in the stretching machine.
3. Can be used in the film thickness adjustment structure of plastic machines.
4. Can be used in lifting structures for heavy objects.
5. Can be used as a closed open structure for high-temperature furnace doors.
6. It can be used for adjusting the height structure of plastic container blowing machine molds.
7. Can be used in the opening and closing structure of water gates. Comparison of the functions of spiral elevators with hydraulic cylinders and pneumatic cylinders (as shown in the table below)
Spiral elevator hydraulic cylinder pneumatic cylinder
It can be started as a single unit or in series with multiple units, and it needs to be powered by an oil pump, an oil tank, and an air compressor
Stable positioning after action, no slipping, easy displacement, easy displacement
Can be used in conjunction with digital detection for fine adjustment of multi-stage positioning or manual adjustment. Only single up and down positioning can be performed. Only single up and down positioning can be performed
Easy to maintain with multiple components
Elevator usage instructions:
Precautions for use
Please strictly select the appropriate speed ratio and the corresponding elevator with sufficient margin of load according to the bearing capacity table;
When the elevator is working, the surface temperature of the reducer and the lifting nut should be controlled between -15 ℃ and 80 ℃;
Elevators shall not operate continuously, and the load time rate (T%) of a single elevator shall be calculated in units of 30 minutes and shall not exceed 20%;
Load rate T%=1 working time of action cycle/(1 working time of action cycle+1 working time of action interval)
Sufficient driving power must be ensured;
Elevators theoretically have self-locking function, but in situations with large vibration and impact, the self-locking function may fail. Please be sure to add a braking device;