LW series electric push rod:

High strength/high wear-resistant material selection, high-precision component processing, advanced shell design concept, create products with high load-bearing capacity, impact resistance, low noise, and long service life, which can work normally in harsh industrial environments. The configuration is divided into ordinary tooth screw electric push rod (working system of 30%) and ball screw electric push rod (working system of 60%), and the specific operating conditions need to be confirmed by both parties.

The drive of the electric push rod can be equipped with DC motor 12/24/36/48V, single-phase/three-phase AC motor 220/380V, stepper motor, servo motor, explosion-proof motor, deceleration motor, etc.

According to the self-locking coefficient, the self-locking performance can be determined, which can achieve synchronous driving of multiple push rods. Configuring an encoder can achieve multi-point precision positioning (position accuracy of 0.1mm, different configurations, different accuracies). There are many accessories, which can be suitable for various special occasions.

Working environment temperature: 5 ℃ -40 ℃. If you need -40 ℃ -+70 ℃, consult a business engineer.

Protection level: IP54, IP55, (IP56, IP65, IP66), insulation level: F level (H level), containing long-life grease, maintenance free, large push rods require appropriate oiling,

Performance parameters of LW02 electric push rod (DC motor 24V/12V)

Environmental temperature: -25---+70 ℃. Load duration rate: 15%/every 10 minutes