Nicknames: H-beam shot blasting machine, sheet shot blasting machine, large shot blasting machine, through shot blasting machine

Main technical parameters of shot blasting machine:

Workpiece conveying system:

The workpiece conveying system consists of a feeding roller conveyor, a chamber roller conveyor, and a discharging roller conveyor. All roller tracks are supported by spherical bearings with seats. The bearing seat is equipped with a straight through oil cup for regular lubrication.

Shot blasting treatment room

The shot blasting treatment room consists of a front auxiliary room, an upper sand blasting room, a rear auxiliary room, a lower chamber body, a shot material circulation purification system, and a shot blasting dust removal system.

The body of the shot blasting treatment room is welded from steel plates. The interior of the room is lined with a 10mm wear-resistant protective plate, fixed with 40Cr hex nuts, which is resistant to projectile impact and easy to install and replace.

The chamber roller conveyor adopts a polyurethane sheath, and the two ends of the roller conveyor are sealed with a labyrinth to prevent pellets from entering the bearing and damaging it.

Multiple layers of rubber sealing curtains are installed at the inlet and outlet of the chamber to prevent bullets from flying out of the chamber. The shot blasting cleaning room is equipped with ventilation ducts and butterfly valves.

During equipment installation and debugging, by adjusting the opening amplitude of the butterfly valve, the dynamic and static pressure of each pipeline on the chamber body can be balanced, resulting in different negative pressures in different parts of the chamber body,

This not only ensures that dust inside the chamber does not overflow, but also allows for preliminary separation and purification of the pellets.

Note: Non standard customized products can be customized according to needs!