Operation Process of Wire Rope Swaging Machine
1. Keep up the good work
Upon arrival of the hydraulic sleeve press, first lubricate the machine with brand 46 anti-wear hydraulic oil.
Fuel quality can affect performance, such as increased noise and slow up and down speeds. Long-term use of poor-quality fuel is prone to damaging the oil pump.
Causes damage, affecting the lifespan of the oil pump. Oil is added through the filter port, ensuring that no impurities enter the oil tank. Add oil to at least...
Level gauge center.
2. Power connection:
Then, connect the power supply according to the voltage of the pressure sleeve machine you purchased (380V or 220V).
3. Machine Test
Now you can start using the machine. Before installing the mold, run it up and down a few times to test it.
Is the circuit functioning properly, and is the machine operating both up and down smoothly?
4. Packaging Mock-up
Mold installation should be noted: the mold should be aligned vertically, with no misalignment strictly prohibited. If the upper and lower mold cavities are misaligned, the pressing operation may be affected.
The finished aluminum sleeve is not smooth, and this uneven wall thickness in the fixed tube results in stress concentration, leading to a failure point in the hoisting rope.
The force test resulted in a fracture at the thin-walled section of the fixed tube.
Technical Specifications:
| Pressure | 3000KN | Power Voltage | 220V or 380V |
| A single pressed rope diameter | Φ26 | Power | 3.7 kW or 4 kW |
| Multiple compression rope diameters | Φ34 | Frequency | 50Hz |
| Itinerary | 90mm | Work pressure | 28Mpa |
| Work Itinerary | 75mm | Piston Upstroke Speed | 4.8/s |
| Dimensions (Length x Width x Height) | 1400×600×1600 | Piston downward speed | 7.8/s |
| Net Weight | 1500kg | Color | Blue hammer pattern or custom design by user |
