MW-108Food-grade composite adhesive liquidA one-component silicone adhesive for bonding silicone to silicone, primarily used for bonding silicone tubes, silicone extrusions, silicone foam boards, silicone gaskets (sealing strips), and various other silicone products. It boasts high strength of bonded silicone, non-crazing, non-aging, and good resilience.
One,Food-grade composite adhesiveWaterproof properties
Composition: Organic Silica, Catalyst, Cross-linking Agent
Appearance: Transparent semi-liquid colloidal.
Specific Gravity (25°C))：0.9～1.0。
Packaging: 100-330g per tube.
Shelf Life: 6 months.
Two,Food-grade composite adhesive liquidUsage Instructions:
MW-108 silicone adhesive cures through moisture in the air (deacidified), thus it has a slower curing rate and a slight odor during the application of the glue (odorless after full curing).FDACertification. Small area of adhesive coating30Approximately 30 minutes to initial set (for movable products)24Fully cured in hours (with side-testable bond strength).
1、Silicone Products
(1) First, apply glue to the silicone surface to be bonded (a scraper can be used to spread it evenly over large areas).
(2): Firmly press the two coated silicone surfaces together to be bonded.
（3Place the bonded silicone products on a flat surface, avoid bending the bonded silicone products as much as possible to prevent deformation of the finished silicone products. If conditions permit, it is recommended to use clamps for shaping.
2Silicone tubes and extrusions
（1Silicone tubes and shaped strips require securing with clamps for proper alignment. The clamp should be released only after the adhesive has初步set.30Minutes roll into hours (specific time to be determined).
（2Gluing Method: First, apply a small amount of adhesive to a flat surface (e.g., steel plate, tile, acrylic board) and spread it evenly with a knife (ensure consistent thickness). Then, press one end of the silicone strip against the flattened adhesive to leave a layer of adhesive on the surface. Align and bond the other end, and secure it with clamps. Once the adhesive is surface-dry, remove the clamps for the next step. It is recommended to bond the adhesive as soon as it is applied to prevent the surface from curing and affecting the bonding strength over time.
Three,Food-grade composite adhesive liquidCautionary Notes:
Store in a dry, cool place.,Keep away from heat sources and open flames.
2Occupational Fire and Ventilation,Avoid long-term inhalation or skin contact. Use protective gloves and eyewear. If adhesive gets on the skin, wash thoroughly with soap. In case it gets into the eyes, rinse with plenty of water and seek medical attention promptly.
This product manual is based on our company's test results and is provided for reference only. Please test the performance of this product yourself before using it and make appropriate adjustments according to your own construction equipment.
