Operation of the fully automatic bending machine must follow certain steps and methods. Do not arbitrarily move buttons to avoid unnecessary loads on the machine. What is the correct way to operate? Next, we will briefly introduce it in order.

Note the operation of the fully automatic bending machine.

1. Automatic bending machines should begin to pay attention to the fact that no one should enter the area swept by the rotating arm.

2. Automatic bending operation, all personnel must cease movement within the sweeping space of the boom and pipeline!

Automatic bending machine, the hydraulic system uses YA-N32 (signature number 20) normal working oil, typically replaced once a year, and the oil filter should be cleaned simultaneously.

4. When adjusting the automatic bending machine (mold), the regulator must be adjusted by pressing the button. One person transitions from manual to fully automatic bending machine operation, while the other operates from the control cabinet.

When adjusting the automatic bending machine or emptying the car, the item must be removed.

6. The hydraulic system pressure must not exceed 14 Mpa. 7. When manually adjusting the speed of the side thrust cylinder, the arm should be rotated to ≥90° for adjustment. The speed adjustment is synchronized with the linear speed of the bending arm elbow rotating arm; in manual mode, the pushing speed of the thrust line is higher, and the mold rotation is stopped. Speed

8. Typically, after a period of using the machine, it is necessary to check and tighten the chain bolts, as well as the upper and lower chains.

9. In the activation mode, the operator must ensure that the mandrel is within the tube or the center axis does not interfere with the appearance upon the return of the bending arm. Otherwise, the center axis or mandrel may bend or crack.