Pneumatically driven hydraulic power system

I. Equipment Introduction

The equipment is driven by compressed air, increasing the pressure of atmospheric pressure liquids up to a maximum of 30MPa. The pipeline system uses non-welded connections. This product employs an air-hydraulic pump method with manual control, allowing adjustable output pressure. It is used for high-pressure injection of hydraulic support emulsion, high-pressure hydraulic pumps, and explosion-proof environments. The equipment can be customized according to the specific operating pressure of the user.

Section II: Equipment Composition

The system consists of an air-liquid booster pump, pneumatic twin unit, high-pressure cut-off valve, pipeline, pressure gauge, and cabinet, etc.

III. Main Technical Parameters

Maximum Pressure: 30 MPa

Working Pressure: 20 MPa

Drive Pressure: 0.3-0.8 MPa

Pressure Ratio: 40x

Water Tank: 12L Built-in Stainless Steel

Standard Flow Rate: 6 L/MIN

Export Thread: ZG3/8 (optional)

Noise: ＜75dB

Control Method: Manual Control

Connection Type: Threaded

Cabinet Material: Stainless Steel Frame

Dimensions: Approximately 55*40*63 cm

Weight: Approximately 35-40 kg

IV. Equipment Features

Driven by compressed air, the output hydraulic pressure is proportional to the driving gas source pressure. Adjusting the driving gas source pressure allows for corresponding hydraulic pressure. When the driving gas source pressure equals the hydraulic pressure, the pneumatic booster pump stops pressurizing, stabilizing the output hydraulic pressure at the pre-set pressure. Thus, it features explosion-proof, adjustable output pressure, compact size, lightweight, simple operation, reliable performance, and wide application range.