Fiberglass Dry Type Transformer with Cable Entry Ceramic Bushing

Product Introduction

This product consists of a carrier fluid, a capacitor core wrapped with impregnated fiber, a composite jacket/wire jacket, a flange, and end structures. Measurement terminals are mounted on the flange, which should be opened for use during partial discharge and dielectric loss factor measurements, and should be reliably grounded during normal operation. Outdoor ends of the product feature equipment clamps.

Reference Standards

Insulation Sleeves for AC Voltage Exceeding 1000V - GB/T 4109-2008

Product Model

Product Features

·Dry-type composite capacitor-type insulation, oil-free, gas-free

High soil resistance level

· Good casing mechanical properties

Terms of Use:

·Ambient Temperature: -40℃ to +50℃

·Altitude: Product design is based on a 1000m altitude; corrections are made according to GB 311 when exceeding 1000m.

· Filth Level: IV (Special requirements, if applicable)

Key Performance Indicators:

· Applicable rated voltage levels: 12~252 kV

· Rated Current: ≤6300A (Special design required for higher current if needed)