What are the operation specifications for used reactors?

2024-10-26

1. The autoclaves should be placed indoors. When multiple autoclaves are equipped, they should be placed separately. Each operation room should have an exit leading directly to the outdoors or a corridor, and the equipment location should have good ventilation.

When installing the kettle lid, prevent the sealing surfaces between the kettle body and lid from colliding. Carefully place the lid in the fixed position on the kettle body, and when tightening the main nut, do so diagonally and symmetrically in multiple steps. Apply even force; do not allow the lid to tilt to one side for a good seal.

3. At the male and female nut connection, only rotate the male and female nuts; do not rotate the two arc sealing surfaces against each other. When assembling all nut thread connection parts, apply lubricating oil.

4. The needle valve series features a tight seal with just a gentle turn of the valve needle, pressing the sealing cover firmly for excellent sealing.

5. Rotate the revolving body on the pot by hand to check for smooth operation.

6. The controller should be placed flat on the operating table. Its operating environment temperature should be between 10-40°C, with a relative humidity of less than 85%, and should not contain conductive dust or corrosive gases in the surrounding medium.

Ensure all moving parts and fixed connections on the front and back panels are functioning properly. Remove the top cover to inspect for loose connections on the plug-in connectors and check for any damage or rust due to improper transportation and storage.

Controllers should be properly grounded.

9. Connect all wires, including power lines, electric furnace lines between the controller and the kettle, motor lines, as well as temperature sensor and speedometer wire lines.

Turn on the main power switch "Power" on the panel, and the digital display should show.