ZG-3LKH Laboratory Small Electrically Heated Water-Cooled Open/Close Molding Compounding Machine
1. Compounding Chamber Volume: 3L
2. Main Motor: AC motor, 7.5 kW power
3. Gearbox: Base and frame made of low-carbon steel structure, equipped with a forced lubrication circulation system.
4. Rotor: Double-edged, synchronous rotor design (also available according to customer-provided rotor structure drawings), front and rear rotor speed ratio of 1:1.20 or ST synchronous rotor specific parameters can be customized according to customer requirements, cast steel quench hardening treatment, surface hard chrome plating; ball bearing roller bearings for bearings; bearing lubrication bath; rotor speed: 3L: 36 rpm, specific speed can be customized according to customer requirements.
5. Walling: Steel structure, drilling and heat treatment, hardened inner surface with hard chrome plating; Bracket: Steel structure, hardened inner surface with hard chrome plating.
6. Top Pin: Cylinder-driven, hard chrome-plated surface. End face sealing: sealing ring made of high-wear-resistant material, self-lubricating bearing, hinge spring pressure seal.
7. Feeding hopper: Manual operation. Control method: manual, semi-automatic; Compounding machine temperature: room temperature +10° to high-temperature compounding machine with 650° at max.
8. Base Frame, constructed from steel beams and plates, welded and processed into shape
9. The mixing chamber's middle slot is made from wear-resistant alloy steel, and the side walls are welded from medium carbon steel plates, then processed.
10. Stirring shaft: The shaft and blades are made of alloy steel. The bearing housing is made of ZG20 steel, and the bearings are roller bearings.
11. Feeding Device - This mechanical design features a front-loading feeding device, with pressure adjustable to the user's preference via an air valve.
12. Leak Prevention Device - The side end of the agitator shaft uses a mechanical shaft seal, with a leak-proof structure certified.
13. Pressure Cap Assembly: Made of alloy steel, applies pressure to the raw materials during mixing operations, utilizing an air cylinder for vertical up and down movement.
14. Discharging Unit: The closed kneader automatically opens pneumatically, allowing material to fall into the collection tray from the middle (easier to retrieve, cleaner to handle)
15. Transmission Structure: Main Motor, 7.5KW AC, Voltage 380V. Transmission Method: The main motor and the reducer are connected for transmission.
16. Air Compressor Pipe Fittings: Compressed air accessories (3-point assembly, solenoid valve) and mechanical body piping
17. Primary Electrical Control Equipment: Temperature Setting: Both automatic and manual options available. With prompt actions, various time settings, and capabilities for forward and reverse operation.
Advantages of the machine unit
18. Key electrical components are of imported brands, with the entire machine bearings using Timken TWB brand.
19. The agitator shaft is made of alloy steel. Wear-prone areas are reinforced with imported German hard-wearing steel, providing enhanced strength and durability.
20. "Mountain" type mixing tank, the main body of the mixing tank is made of wear-resistant alloy steel, and the cutting section is surfacing with German sharp steel.
21. Side wall leak prevention device made with high-tech materials: Leak-proof structure certified
22. The pressure cap is designed with an "M" type structure, ensuring more even rubber material mixing.
23. Volume: (W×D×H) 1450*600*1590MM
24. Weight: 450 kg
