Operation Process of Wire Rope Swaging Machine
Keep up the good work.
After the extrusion sleeve machine arrives, first oil it with brand 46 anti-wear hydraulic oil, avoid substandard...
Fuel quality can affect performance, such as increased noise and slower up and down speeds. Long-term use of poor-quality fuel is prone to damage the oil pump.
Causing damage, affecting the lifespan of the oil pump. Oil is added through the filter port, ensuring no impurities enter the oil tank. Add oil to at least...
Level gauge center line.
2. Power Connection:
Then, plug in the machine according to the voltage of the collar press you purchased (380V or 220V).
3. Machine Test
Now you can turn on the machine and start using it. Before installing the mold, run it up and down a few times to test it out.
Is the circuit functioning properly, and is the machine operating both up and down as it should?
4. Packaging mock-up
Mold installation should be noted: the mold should be aligned vertically, no misalignment is allowed. If the upper and lower mold cavities are misaligned, the pressing
The finished aluminum sleeve exhibits an uneven surface finish, and such a fixed pipe wall thickness inconsistency leads to stress concentration, causing the hoisting rope to break under tension.
Fractured at the thin-walled section during tensile testing.
Technical Specifications:
| Pressure | 5000KN | Power Voltage | 220V or 380V |
| One-time compression rope diameter | Φ32 | Power | 5.5KW |
| Multiple diameter rope压制 | Φ40 | Frequency | 50Hz |
| Itinerary | 130mm | Work pressure | 28Mpa |
| Work itinerary | 80mm | Piston upward speed | 5.6/s |
| Dimensions (Length x Width x Height) | 1600×680×1880 | Piston downstroke speed | 9.8/s |
| Net Weight | 3000kg | Color | Blue hammer texture or customer-defined |
