Operation Process of the Wire Rope Sizer Machine
1. Keep up the good work.
After the hydraulic press arrives, first oil the press with brand 46 anti-wear hydraulic oil, avoid low-quality
Fuel quality can affect performance, such as increased noise and slower up and down speeds. Long-term use of poor-quality fuel can easily damage the oil pump.
Cause damage, affecting the lifespan of the oil pump. Oil is added through the filter port to ensure no impurities enter the oil tank. Oil should be added at least to...
Level gauge center line.
2. Power Connection:
Then, connect the power supply according to the voltage of the press sleeve machine you purchased (380V or 220V).
3. Machine Trial
Now you can start using the machine. Before installing the mold, run it up and down a few times to test it.
Is the circuit functioning properly, and is the machinery operating up and down as it should?
4. Packaging Model:
Mold assembly should be noted: the mold should be aligned vertically, no misalignment is allowed. If the upper and lower mold cavities are misaligned, the pressing process may be affected.
The finished aluminum sleeve exhibits an uneven surface, and such uneven wall thickness in the fixed tube leads to stress concentration, which may cause the rope to break under tension.
The force test resulted in a fracture at the thin-walled section of the rigid connector.
Technical Specifications:
| Pressure | 2000KN | Power Voltage | 220V or 380V |
| One-time pressed rope diameter | Φ20 | Power | 3.5KW or 4KW |
| Multiple diameter rope compression | Φ26 | Frequency | 50Hz |
| Itinerary | 85mm | Work pressure | 28Mpa |
| Work Itinerary | 70mm | Piston upward speed | 5.6/s |
| Dimensions (Length x Width x Height) | 1200×600×980 | Piston downstroke speed | 8.6/s |
| Net Weight | 760kg | Color | Blue hammer pattern or custom design by user |
