The Demagnetizer (hereinafter referred to as the Demagnetizer) is suitable for circuits with an AC frequency of 50 Hz and voltage up to 380 volts. It is used to remove residual magnetism from parts that are mechanically processed using a fixed electromagnetic attraction method.
The main parameters of the degausser are the rated working voltage of the winding, which is AC 127, 220, and 380 volts.
Demagnetizer is suitable for a voltage frequency of 50 Hz and a power factor of 60%.
Model TC-1 TC-2
Top Surface Dimensions: 163*120*90 (mm), 220*163*90 (mm)
Installation hole spacing: 172+-0.2 (mm), 174+-0.5 (mm)
Aperture: Two holes on each side with a diameter of 7mm each.

Technical Requirements:

The degaussing unit should ensure reliable and operational performance under the following conditions:

Height not exceeding 1000 meters.

Ambient air temperature must not exceed 40°C and must not be below -30°C.

Air and temperature not exceeding 85% (at +20°C).

In media that are free from danger, and free from gases and dust (including conductive dust) that are capable of corroding metals and damaging insulation.

In places unaffected by rain and fog.