1000T Wire Rope Swaging Machine

Operation Process of Wire Rope Swaging Machine

1. Keep up the good work

After the press fitting machine arrives, first oil the machine using brand 46 anti-wear hydraulic oil.

Fuel quality can affect performance, such as increased noise and slow acceleration and deceleration. Prolonged use of poor-quality fuel can easily damage the oil pump.

Causing damage, affecting the lifespan of the oil pump. Oil is added through the filter opening, ensuring that no impurities enter the oil tank. Add oil to at least...

Level gauge center line.

2. Power Connection:

Then, connect the power supply according to the voltage of the press sleeve machine you purchased (380V or 220V).

3. Machine Test

Now you can start using the machine. Before installing the mold, run it up and down a few times to test it.

Is the circuit functioning properly, and is the machine operating up and down as it should?

4. Packaging Model:

The mold should be properly aligned, ensuring that the upper and lower mold cavities are perfectly matched. Misalignment is strictly prohibited. If there is misalignment between the upper and lower mold cavities, the pressing process should be halted.

The finished aluminum sleeve exhibits an uneven surface finish, and such a fixed pipe wall thickness inconsistency leads to stress concentration, which can cause the hoisting rope to break under tension.

Fractured at the thin-walled section during tensile testing.

Technical Specifications:

   The models displayed on our website are our standard types, and we can customize wire rope swaging machines from 10T to 5000T according to customer requirements.