2000T Wire Rope Sizer Machine

Rope Clamp Machine Operating Procedure

1. Keep up the good work.

Upon arrival of the hydraulic press fitting machine, first oil it with brand 46 anti-wear hydraulic oil.

Fuel quality can affect performance, such as increased noise and slow acceleration and deceleration. Prolonged use of poor-quality fuel is prone to damage the oil pump.

Cause damage, affecting the lifespan of the oil pump. Oil is added through the filter port, ensuring no impurities enter the oil tank. Oil should be added to at least...

Level gauge midpoint.

2. Power Connection:

Then, connect the power supply according to the voltage of the press sleeve machine you purchased (380V or 220V).

3. Machine Test

Now you can start using the machine. Before installing the mold, run it up and down a few times to test it.

Is the circuit functioning properly, and is the machine operating up and down as it should?

4. Dummy packaging

Mold installation should be noted: the mold should be aligned vertically, with no misalignment strictly prohibited. If the upper and lower mold cavities are misaligned, the pressing process may be affected.

The finished aluminum sleeve shows an uneven surface finish, which leads to uneven wall thickness in the fixed pipe, causing stress concentration and potential failure of the hoisting rope.

Fractured at the thin-walled section of the fixed pipe during tensile testing.

Technical Specifications:

    The models displayed on our website are our standard types, and we can customize wire rope swaging machines ranging from 10T to 5000T to meet customer requirements.