3000T Wire Rope Sizing Machine

Operation Process of Wire Rope Crimping Machine

1. Keep up the good work.

Upon arrival of the hydraulic sleeve machine, first lubricate it with brand 46 anti-wear hydraulic oil.

Fuel quality can affect performance, such as increased noise and slow acceleration and deceleration. Prolonged use of poor-quality fuel can easily damage the oil pump.

Cause damage, affecting the lifespan of the oil pump. Oil is added through the filter port, ensuring that no impurities enter the oil tank. Oil should be added to at least...

Level gauge center line.

2. Power Connection:

Then, connect the power according to the voltage of the die-casting machine you purchased (380V or 220V).

3. Machine Test

Now you can start using the machine. Before installing the mold, run it up and down a few times to test it out.

Is the circuit functioning properly, and is the machine operating both up and down correctly?

4. Mock-up

The mold should be aligned properly, ensuring that the upper and lower mold cavities are perfectly matched. Misalignment is strictly prohibited. If the mold cavities are misaligned, the pressing process may be affected.

The finished aluminum sleeve exhibits an uneven surface finish, and such a fixed pipe wall thickness inconsistency leads to stress concentration, which may cause the hoisting rope to break under tension.

The force test resulted in a fracture at the thin-walled section of the rigid connection.

Technical Specifications:

The models displayed on our website are our standard types, and we can customize wire rope swaging machines ranging from 10T to 5000T according to customer requirements.