650T Wire Rope Swaging Machine

Rope Inserting Machine Operation Process

1. Keep up the good work.

After the press sleeve machine arrives, first oil the machine with brand 46 anti-wear hydraulic oil, avoid low-quality

Fuel quality can affect performance, such as increased noise and slower up and down speeds. Prolonged use of poor-quality fuel can easily damage the oil pump.

Causes damage, affecting the lifespan of the oil pump. Oil is added through the filter opening, ensuring that there is no contamination in the oil tank. Oil should be added at least to

Level gauge center line.

2. Power Connection:

Then, connect the power supply according to the voltage of the extruder you purchased (380V or 220V).

3. Machine Test

Now you can start using the machine. Before installing the mold, run it up and down a few times to test it out.

Is the circuit functioning properly, and is the machine operating both up and down correctly?

4. Mock-up

The mold should be aligned properly, ensuring the upper and lower mold cavities are perfectly matched. Misalignment is strictly prohibited. If there is misalignment between the upper and lower mold cavities, the pressing operation is not allowed.

The finished aluminum sleeve exhibits an uneven surface finish, and such a fixed joint with uneven wall thickness leads to stress concentration, which can cause the hoisting rope to break under tension.

The force test resulted in a fracture at the thin-walled section of the fixed tube.

Technical Specifications:

   Website displays standard models of our company, customized wire rope sleeve machines from 10T to 5000T available upon customer's request.