800T Wire Rope Swaging Machine

Operation Process of Wire Rope Swaging Machine

1. Keep up the good work.

After the hydraulic sleeve press arrives, first oil the press with brand 46 anti-wear hydraulic oil.

Fuel quality can affect performance, such as increased noise and slow acceleration and deceleration. Long-term use of low-quality fuel can easily damage the oil pump.

Cause damage, affecting the lifespan of the oil pump. Oil is added through the filter port to ensure that there is no impurities entering the oil tank. Oil should be added to at least...

Level gauge center line.

2. Power connection:

Then, connect the power supply according to the voltage of the press sleeve machine you purchased (380V or 220V).

3. Machine Test

Now you can start using the machine. Before installing the mold, run it up and down a few times to test it out.

Is the circuit functioning properly, and is the machine operating up and down correctly?

4. Mock-up

The mold should be aligned properly, ensuring that the upper and lower mold cavities are perfectly matched. Misalignment is strictly prohibited. If there is misalignment between the upper and lower mold cavities, the pressing process may be compromised.

The finished aluminum sleeve is not smooth, and such a fixed pipe with uneven wall thickness can cause stress concentration, leading to a potential failure point in the hoisting rope.

Fractured during the tensile test from the thin-walled section of the fixed tube.

Technical Specifications:

   The models displayed on the website are our standard designs, and we offer customization services for wire rope swaging machines ranging from 10T to 5000T according to customer requirements.