The Demagnetizer (hereinafter referred to as the Demagnetizer) is suitable for circuits with an AC frequency of 50 Hz and voltage up to 380 volts. It is used to remove residual magnetism from parts that are mechanically processed using a fixed electromagnetic attraction method.
The main parameters of the degaussing unit are the rated working voltage of the winding, which is AC 127, 220, and 380 volts.
The degaussing coil is suitable for a voltage frequency of 50 Hz and an energization rate of 60%.
Model TC-1, TC-2
Top surface dimensions: 163*120*90 (mm), 220*163*90 (mm)
Installation hole pitch: 172+-0.2 (mm), 174+-0.5 (mm)
Hole diameter: Approximately 2 holes with a diameter of 7mm each

Technical Requirements:

The demagnetizer should ensure reliable and operational performance under the following conditions:

No taller than 1,000 meters.

The surrounding air temperature must not exceed 40°C and must be no lower than -30°C.

Air and temperature not exceeding 85% (at +20°C).

In a medium free from danger, and without gases and dust (including conductive dust) that are capable of corroding metals and damaging insulation.

In regions unaffected by rain and fog.